So in summary the following four items should be associated to the component in the library of the circuit designing software:ġ.Component Symbol: The library should have the component symbol in the library. In the same way three dimensional model of the component should also be available in order to have the three dimensional visualization of the circuit. Just as the symbol is necessary for the schematic drawing and simulation model is critical for simulation the PCB footprint should also be present in the library of the software for printed circuit board design. If the simulation model of the component to be used is not available in the library then the software will not be able to run the simulation. The symbol of the component to be used in the schematic must be available in the library of the software for schematic drawing, in the similar way the simulation model of the specific component to be placed in the schematic is also very important. In order to draw the schematic in the any circuit simulation software you need the library which holds the symbol of the component to be used in the schematic. Proteus can also be used as the development tool in which you can write and simulate the code on any microcontroller. Proteus is the circuit simulation software and can also be used for printed circuit board design. So sit back, keep reading and enjoy learning. After reading this post you will be able to learn the schematic drawing in Proteus and the designing of the printed circuit board in the Proteus, you will also learn about how to visualize the three dimensional view of the circuit in Proteus.

Component ss8550 library proteus